Back to listing
SHOW SIDEBAR
wiring:vibepixel60lpmrgb

Section: Basic Hardware Setup | Controller: HYP-FX-SC-DIG-M-15A (DIG-ALED) | Strip: Vibe Pixel 60LPM RGB | SKU: HYP-FX-60-RGB

Strip Overview

Specification Value
Easy Name Standard Color
SKU HYP-FX-60-RGB
Technology Standard discrete LEDs
LED Density 60 LEDs per meter
Color Channels RGB
Roll Length 5 meters (16.4 ft)
Voltage 12 V DC
Addressing Digital, individually addressable
Warranty 5 Years
This is the standard-density addressable RGB strip. At 60 LEDs/m the individual LED dots are visible at close range. For a dot-free finish, use the COB variants (720 or 784 LPM). This strip is well suited for installations where the strip is behind a diffuser or at distance.



Cuttable 60LPM Strip Locations

What You Need

  • HYPNOTIK FX DIG-ALED controller (HYP-FX-SC-DIG-M-15A)
  • Vibe Pixel 60LPM RGB strip (HYP-FX-60-RGB)
  • 12 V power supply
  • Connection wire or compatible strip connector

Wiring Diagram



Wiring Diagram for 60LPM RGB Strip

Terminal Connections

Controller Terminal Wire Strip Pad
+ (12 V out) Red + / VCC
− (GND) Black − / GND
DATA Green / Signal DIN / DATA IN

Step-by-Step Connection

  1. Power off the controller and power supply.
  2. Identify the input end of the 60LPM strip (arrow pointing into the strip or IN label).
  3. Connect +12 V → + pad.
  4. Connect GND → − pad.
  5. Connect DATA → DIN pad.
  6. Verify all connections and power on.

Firmware Settings

Go to Settings → LED Preferences:

Setting Value
LED Type WS2812B
Color Order GRB
Data Pin GPIO 13 (default)
LED Count 60 × (strip length in meters) — e.g., 300 for a 5 m roll

Wiring: Vibe Pixel 144LPM RGB

Prev Post

Wiring: Vibe Pixel COB 720LPM RGB

Next Post